MarketPlace
692 topics in this forum
-
- 4 replies
- 812 views
-
- 3 replies
- 949 views
-
- 3 replies
- 737 views
-
- 1 reply
- 809 views
-
- 7 replies
- 1283 views
-
- 0 replies
- 696 views
-
- 1 reply
- 2022 views
-
- 7 replies
- 1395 views
-
- 0 replies
- 597 views
-
- 1 reply
- 546 views
-
- 5 replies
- 686 views
-
- 9 replies
- 686 views
-
- 0 replies
- 1069 views
-
- 3 replies
- 801 views
-
- 7 replies
- 912 views
-
- 0 replies
- 576 views
-
- 2 replies
- 967 views
-
- 6 replies
- 751 views
-
- 5 replies
- 1487 views
-
- 0 replies
- 472 views
-
- 5 replies
- 825 views
-
- 10 replies
- 764 views
-
- 19 replies
- 1013 views
-
- 6 replies
- 892 views
-
- 10 replies
- 851 views
-
Who's Online 15 Members, 0 Anonymous, 1 Guest (See full list)
-
Forum Statistics
28403
Total Topics382191
Total Posts -
Member Statistics
-
Topics
-
-
Posts
-
By derekcohen · Posted
Thanks CO. The mitres do need to be cut fat at first since I wish to avoid the danger of over-cutting them. It is safer to pare the waste, and if you are going to do this anyway, a smidgeon of fat there in the beginning does not matter. Plus, in the current build it is not possible to undercut/pare the mitres to make them fit. The reason is the inside edge on the model calls for a bevel/mitre all the way around. I plan to do a slight cove. An undercut would open up the mitre from the inside, and any undercutting would show. Regards from Perth Derek -
-
-
By treeslayer · Posted
Good to hear you’re doing well @B1rdhunter snow and cold here for the next week or so, shots helped but I think a new knee is in my future -
By B1rdhunter · Posted
To much snow and ice to do anything but keep my feet close to the ground. Knees are doing well though. I wonder how Dave is getting along with his shots?
-
-
Popular Contributors
