MarketPlace
745 topics in this forum
-
- 0 replies
- 1.3k views
-
- 1 reply
- 1.3k views
-
- 3 replies
- 1.3k views
-
- 5 replies
- 1.5k views
-
- 2 replies
- 1.4k views
-
- 0 replies
- 946 views
-
- 0 replies
- 1.3k views
-
- 1 reply
- 2.6k views
-
- 2 replies
- 1.3k views
-
- 26 replies
- 3.2k views
-
- 6 replies
- 1.5k views
-
- 12 replies
- 2.3k views
-
- 0 replies
- 1.3k views
-
- 4 replies
- 1.3k views
-
- 4 replies
- 1.6k views
-
- 3 replies
- 1.3k views
-
- 2 replies
- 953 views
-
- 4 replies
- 2.9k views
-
- 0 replies
- 988 views
-
- 1 reply
- 2.7k views
-
- 7 replies
- 1.7k views
-
- 9 replies
- 3.3k views
-
- 0 replies
- 1.1k views
-
- 0 replies
- 1k views
-
- 1 reply
- 1.7k views
-
Who's Online 0 Members, 0 Anonymous, 52 Guests (See full list)
- There are no registered users currently online
-
Forum Statistics
31.2k
Total Topics422k
Total Posts -
Member Statistics
23,768
Total Members3,644
Most Online
-
Topics
-
-
Posts
-
Find a place that’s accessible and not adjacent to the possible fire source. -
Thanks for the update. I'm going to try and put this under the sink or in the pantry cabinet right behind the stove so probably won't even use the bracket. -
Having carved the edges of the corner posts, next it was time for the faces ... First I wanted to continue the bead from the edge onto the face. Unfortunately the largest scraper I had for my beading tool was too small. However, I did have the perfect size blade for my plough plane. Obviously the plane can't be used on this complex curved edge, so I made a small jig to hold the blade as a scraper. Unfortunately the scraper jig couldn't get into the tight corners, so I ended up using the blade as a chisel, with gentle taps from the small mallet to finish of the grooves. Then with the grooves cut, the bead was rounded over, some pattern carved into the face, and the corner posts are ready. I used a few dowels on the posts to keep them aligned during gluing, since it wasn't an easy geometry to clamp -
Cherry also has a nice sap/heartwood contrast if you can boards with sap wood.
-
@legenddc, I just made a correction to my last post. There is a letter T after the model number instead of a K so you are getting one with a light duty vehicle bracket which is fine as it secures it to the wall and not just hanging from a hook.
-
-
Popular Contributors
