Thanks much. One of the trickier details was fitting the doors to the cloud lift arch. trying to get the consistent reveal all the way around took some thought. Here's how I wound up doing it.
I first matched the upper door rail to the bottom of the cloud lift and clamped it in place with the spacers I use for the offset.
Then I added the right stile, again with the offset, then the bottom, just working my way around. That method worked out really well.
Once all four pieces were in place I scribed the panel to fit and added in the offset for the dado. The back of the panel had to be flush with the back since the actual drawer fronts are attached to it.
The planes cut fine when I use them on an edge, just to try the setup, but when I try to cut dado walls I find it very difficult. Maybe I should set the fence a bit lower, so as to prevent the base of the plane from touching the bottom of the dado if you know what I mean. I will try that next time.