• Topics

  • Posts

    • You're rolling!  The sash job, that I started over six months ago (can't remember when it was really), is still at this stage.  Not a stick has moved since then.  I got sidetracked, which is not unusual.  Those computer parts, in the background, are still there too, as well as a bunch of unopened tools still in boxes added since that picture was taken.  
    • It was a new house. The only thing that really sucked was the jointer. I guess plywood is a PITA but i don't use it all that much and when i do I break it down in the garage. Moving stuff in sucks yes, but my shop is 64 degrees year round, has 9 foot ceilings, and full plumbing. Some day we might put an addition on the house. At that time i'll add on to my shop and put in a man door or something that goes strait, and to the garage or something.
    • I went to use one of my bessey clamps a couple days ago, and suddenly my shelf was not sitting square and tight in my case. Took the shelf out, fiddled a bit, and then the gap was on the opposite corner! (I had ended up reversing the orientation of the clamp) Mine was out of square by about the same amount shown in OP’s pic. Grabbed another off my wall and it was correct- just slightly out of square in the opposite direction. I was in HD yesterday and took one of their nicer speed squares over to the clamps and one of the four 24” clamps they had on the shelf was like this. I’ll be sure to check them before I buy them in the future. 
    • Very nice, like the clean lines and the attention to detail with the continuous grain. Did you use anything to reinforce the miter joints? I'm assuming dominos but wasn't sure. I agree with you on the MCM stuff, kind of grows on you. 
    • dude I think I would have bought a new house before I moved all that in basement. or built a ramp  
  • Popular Contributors