Sander Stand

This is really nice. Any particulars on the design? I need to make one. Any suggestions?

This is really nice. Any particulars on the design? I need to make one. Any suggestions?

I used 3/4" pine for the sides and 1/4" ply for the back/shelves. The openeing is slightly wider than my sander (about 5.5") and I spaces the shelves 2" apart. I then added a 1/4" dowel on the side using a bradpoint bit to make the hole. Oh, sides are grooved about 3/4" in from the back to add a support rail along the back so that I can hang it on a hood in the wall. That allows me to move it where-ever I need it.

It was the first project I did without drawing it up in sketchup first.

Sorry for the slow reply, I didn't get a notification.

I like this might have to build one for myself.