Tumbles1982

Members
  • Content Count

    20
  • Joined

  • Last visited

Community Reputation

1 Neutral

About Tumbles1982

  • Rank
    Apprentice Poster

Profile Information

  • Woodworking Interests
    Furniture construction and generally making sawdust

Recent Profile Visitors

514 profile views
  1. Round is easy and square is hard. There you go! Square isn't worth the extra effort in my humble opinion. Sent from my iPhone using Tapatalk
  2. Do you have a machinery hire place nearby? They should have a hand pulled forklift that would do the trick. http://upload.ecvv.com/upload/Product/20087/China_hand_pallet_truck20087221517181.jpg Sent from my iPhone using Tapatalk
  3. t All finished. Sent from my iPhone using Tapatalk
  4. I would personally put this in my screw that, too dangerous category. You may well find the table saw arbor is not long enough to hold a dado stack anyway. If it were me I'd save to upgrade the saw and find another way to do the cut I want the dado blade to do. Usually there's a way to do it with a router if you have one? Sent from my iPhone using Tapatalk
  5. As above, and try mineral spirits if water doesn't work Sent from my iPhone using Tapatalk
  6. 2nd paint it. Stain won't make it look any better. Sent from my iPhone using Tapatalk
  7. Making the swivelling clocks the Marc did a video of, but making the back a magnet closed photo frame. Well that's the plan anyway. We'll see how I get on! Sent from my iPhone using Tapatalk
  8. No expert, but I would think a card or cabinet scraper would be ideal to flatten the knot. Or a belt sander. Sent from my iPhone using Tapatalk
  9. Depends on the exact style of your riving knife, but you may be able to get a machine shop to just thin it for you? Sent from my iPhone using Tapatalk
  10. Wow. That's all I can say. Sent from my iPhone using Tapatalk
  11. One of the photos in the review post shows me holding a ruler to it. It's way out. The real effect in terms of inaccuracy is very small though. Having said that I am investigating replacing it with stick on tape. I'm just looking for one that's got both inches and cm and looks like similar to the original. Or I might just lift it and stick back down straight I haven't decided yet. Did you get yours in the latest batch or had it for a while? Sent from my iPhone using Tapatalk
  12. Vice: left side if right handed, right side if left handed. Makes the mechanics of planing work easier. Depends on how you plan to use your bench, but I'd imagine putting it in the middle will just get in the way. Ideally I think the legs should be placed such that they balance the top with as much top mass inside the legs as outside. That means the top is less likely to sag outside or inside the leg supports. The other consideration is that most people like their front vice on the outside of their legs. Sometimes this means biasing the base to one side to make room. Sent from my iPhone using Tapatalk
  13. Try just wiping it with mineral spirits Sent from my iPhone using Tapatalk
  14. Here's a couple more photos. 1 showing a plastic laminate cut. I really like that Fusion blade! The other is the stamp on the side of the motor showing 2hp and less than 10a rating. I just took delivery of a dado stack today so will see how the saw goes with that. I've had no issues with the full kerf blade so far. Sent from my iPhone using Tapatalk
  15. Another one for the diablo combination blade. I wouldn't think a zci would impact saw marks, just tearout. But suffice to say, use a zci as well. They say you only need to sand to about 120 grit for edges you are going to glue, so blade marks that aren't too severe I'd just go straight to glueing provided I can clamp them adequately. Sent from my iPhone using Tapatalk