• Content Count

  • Joined

  • Last visited

Community Reputation

0 Neutral

Profile Information

  • Woodworking Interests

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

  1. Building a basement bar. Bar top is maple veneer plywood. Bar was attached by screws from underneath. Two screws pushed veneer up and caused small crack. Backing out screws did not flatten the veneer. Looking for suggestions to reduce/remove dimple prior to applying finish.
  2. Thanks. I was figuring that I would have to buy maple but hoped to save the extra cost and time in getting the maple crown.
  3. Working on a project with maple hardwood. Need a crown molding. Found an oak one and did a sample staining but it stained much darker. Any suggestions to reduce the stain absorption would be appreciated. Only need about 10 ft and oak is easily available and acceptable or do I need to purchase maple crown?