Babs

Members
  • Content Count

    2
  • Joined

  • Last visited

Community Reputation

2 Neutral

Profile Information

  • Woodworking Interests
    hobbyist. small crafts mostly. aspire to furniture making.

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

  1. Thank you all for your advice. I have seen the link V-belts at Rockler. They're a bit pricey. I didn't realize Harbor Freight carries them so I'll look for them there. Was thinking about replacing the belt on my bandsaw with a link belt to reduce the vibration. Will wait until I actually have the jointer and can take off the old belt and measure before purchasing a new one. Same with the cutter blades. Looks like this place may carry the right size jointer knives/cutters, https://www.americannationalknife.com/?gclid=CjwKCAjw9r-DBhBxEiwA9qYUpdT4EeX4JhqnjU1l5IN2NgJQBq53QNf8KfBDTNzeakI3Lib
  2. I inherited my father's circa 1950's Craftsman 6 inch jointer. Model 103.20660. I need to purchase a new set of cutter blades and a pulley for the motor. Manual says it takes a 1/2 inch Vee type belt but doesn't specify the size. Does anyone know where I might purchase parts? I tried Sears Parts direct but they don't have anything with this model number. I can't measure the pulley as I'm in Maine and it is still in Indiana. I wanted to purchase the parts before I drive back to pick it up next month. Any advice on restoring will be helpful. Thanks.