jussi Posted February 17, 2016 Report Share Posted February 17, 2016 http://www.amazon.com/gp/product/B016S81G5A?psc=1&redirect=true&ref_=oh_aui_detailpage_o00_s00 It's oos but it looks like you can still order it and will ship when available. Retail is $140 I believe. At least that's what woodcraft sells it for http://www.woodcraft.com/product/161430/kreg-27-x-69-universal-clamp-trak-kit-kreg-kks2769.aspx Link to comment Share on other sites More sharing options...
wdwerker Posted February 17, 2016 Report Share Posted February 17, 2016 I have a couple of those. They are quite heavy duty but overpriced. When lesser tracks bent under heavy clamping demands they hold up . I guess it boils down to if you want quality you have to pay for it. Link to comment Share on other sites More sharing options...
Tom Cancelleri Posted February 17, 2016 Report Share Posted February 17, 2016 I posted that in chat yesterday. I thought about ordering some, however I can't imagine I need more work holding than the Roubo. I guess it'd be nice for an assembly table, but that means I have to build one. Link to comment Share on other sites More sharing options...
Brendon_t Posted February 17, 2016 Report Share Posted February 17, 2016 1 minute ago, Tom Cancelleri said: I posted that in chat yesterday. I thought about ordering some, however I can't imagine I need more work holding than the Roubo. I guess it'd be nice for an assembly table, but that means I have to build one. So you haven't run into any situation yet you needed more face clamping? I was just taking to shane about his setup thinking it may be a nice addition to the laminate strip Link to comment Share on other sites More sharing options...
Tom Cancelleri Posted February 17, 2016 Report Share Posted February 17, 2016 Just now, Brendon_t said: So you haven't run into any situation yet you needed more face clamping? I was just taking to shane about his setup thinking it may be a nice addition to the laminate strip Holdfasts work wonders Link to comment Share on other sites More sharing options...
Brendon_t Posted February 17, 2016 Report Share Posted February 17, 2016 I hope so. I've never had a bench that could use them. Link to comment Share on other sites More sharing options...
Immortan D Posted February 17, 2016 Report Share Posted February 17, 2016 34 minutes ago, Brendon_t said: So you haven't run into any situation yet you needed more face clamping? I was just taking to shane about his setup thinking it may be a nice addition to the laminate strip Shane uses the Festool clamps. The Kreg clamps have way too much leverage. I have one of each (old style and automaxx). IMO holdfasts or similar clamps give just about the required clamping force without risk of tearing your bench apart, or damaging the thread on the 3/8 screw that attaches the Kreg clamp. Link to comment Share on other sites More sharing options...
jussi Posted February 18, 2016 Author Report Share Posted February 18, 2016 I'm planning on using it on my assembly table. I built the ubiquitous torsion box assembly table a while back and it doubles as an out feed table. I have an mft but really like the added space of the assembly table especially for connecting large face frames via pocket screws. I actually bought the kreg clamping table on craigslist a while back. It worked well but had to sell it because I didn't have enough room after getting more stationary tools. Hopefully this setup will be just as good. Link to comment Share on other sites More sharing options...
Recommended Posts