Popular Post freedhardwoods 506 Posted October 22, 2020 Popular Post Report Share Posted October 22, 2020 I saw this on another forum. You set it for size, you tighten the nut, you check the size, you loosen the nut, You set it for size, you tighten the nut, you check the size, you loosen the nut, You set it for size, you tighten the nut, you check the size, you loosen the nut, You set it for size, you tighten the nut, you check the size, you loosen the nut,.................. I have one. It isn't quite that bad, but close. 7 Quote Link to post Share on other sites
Chet 4820 Posted October 23, 2020 Report Share Posted October 23, 2020 I had one of the very first additions of the wobble dado and the registration marks for setting it were probably 1/8 inch off, no help at all. Quote Link to post Share on other sites
Wimayo 84 Posted November 19, 2020 Report Share Posted November 19, 2020 Interesting. I have had a Craftsman wobble dado since probably the late 60s. Still have it and I use it once in a while. I've always been amazed that the bottom of the cut is nearly flat. To the point, the index marks are quite accurate also. At most, it may require a slight tweaking depending on how particular I am at the time. It's a scary darn thing. Quote Link to post Share on other sites
RichardA 4975 Posted November 19, 2020 Report Share Posted November 19, 2020 A spinning metal object with sharp teeth doing a wobble? I'm outa there ASAP. Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.