Board game table jointery help


Recommended Posts

I want to build a table like this. I have some almost 2 inch thick oak to use as the arm rest around the perimeter of the table. My question is what is the best and most secure way to attach these 4 perimeter pieces while also accounting for wood movement. Should I just do a butt joint with dowels as I have a great doweling jig? Should I do a mitered joint and just glue the two together? A miter with a spline? Or should I do a mortise and tenon with a dowel to allow for movement? Any advise is appreciated.

 

 

 

There is link to image 

Table Image.jpg

Link to post
Share on other sites

The rails don't look all that wide maybe 4"-5". You could do all of your methods and be ok. Bridle joint is another possibility and is the one that is used on the wood whisperer guild project. If you are looking to build this table that project could be well worth your money.

I'd probably go splined miter if i was building the table. Wide miters can be difficult to get to close evenly as 45 degree angles can be tricky. If you are confidant on nailing the miters a M&T butt joint would be my 2nd go to. Dowels would also work.

  • Like 1
Link to post
Share on other sites

As long as these pieces are, they will be extremely difficult to cut on your table saw. I would consider using half lap joints cut with a hand held router. And as  @Chestnutmentioned, Marc’s project would be well worth the money

Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.