Craftex CX 208 table saw riving knife adjustment


Recommended Posts

Anyone have the 208 and set it up? I'm having difficulties with the riving knife alignment. It came about 1/4 inch (maybe 3/8) out of alignment. Of the four set screws the two bottom ones are tough to access and one of them is nearly impossible. It almost seems like the entire dust shroud needs to come off just to access it. There's also two cap screws that I think need to be loosened (?) but one doesn't seem accessible without possibly removing the locking lever. Any tips? Other than extreme patience and lots of time on my hands (I have little of the former and only a bit of the latter...).



Sent from my iPhone using Tapatalk

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.