Recommended Posts

Posted

"Common Knowledge" is that this won't work...

 

As I searched the 'net for people who may have done this, I found ONE guy who said he did this at work.  All other threads I found repeated "you can't" and "it won't work", in fact I've personally told people it won't work.  The one guy who claimed to try it was essentially ignored.

 

Needing to cut some stringing, and wishing I had a thinner kerf for dovetail tails, and not wanting to spend $160 on a good 1/16" kerf 10" blade, I decided to try it myself.  With the 8" dado brake installed, adjusted all the way to the inner limit, it works!   The brake does not reach all the way to SawStop's recommended maximum gap, but it's close, and it satisfies the blade sensing circuit.

 

If you try this yourself, don't blame me if you hurt yourself, damage your saw, or degrade the effectiveness of the SawStop safety feature.  This probably voids the warranty.   Just because I did this safely doesn't mean you should try it, and is no guarantee of your safety using your saw / blade / skill combination.  Tools change from one manufacturing run to another.   My saw may have minor differences from yours that may change the results.  You take full responsibility for you, your saw, and your work, if you choose to try your small blade in your saw.

 

Video Here

 

 

Blade side comparisons:

 

photo.jpg

 

photo2.jpg

 

POST passed...

photo1.jpg

Posted

Well, at the very least it is no more dangerous than doing the same thing in a standard table saw, I would assume.    Perhaps maybe using too small a blade could somehow cause a false trigger, or the braking mechanism would smash the blade to smithereens.  If I did this on my sawstop, I'd probably deactivate the brake just to avoid those risks. 

 

 

Exactly!   I made the actual cuts in bypass mode for the reasons you wrote.  As you know, if the system doesn't sense a blade presence, it won't go green.  No green LED means it won't start at all, regardless of the bypass key position.  Once you can actually get it to spin up, you can bypass.  Setting back to a proper blade is cake, because I keep Go / No-Go shims and a T-handle hex key at the saw.

 

Sometimes, I really like a very skinny blade, and missed being able to use one after moving to this saw.   I've shared my finding with a guy who has three of 'em, so it'll be interesting to see if this varies from machine to machine.  

 

Obviously, the riving knife won't work with these blades.  All my skinny kerf rips are in thin material like stringing or banding components, so I'm not concerned about the lack of a riving knife.  The other cuts, like corner splines, built-up bandings, and DT tails are in sleds, so no worries there, either.

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Who's Online   1 Member, 0 Anonymous, 44 Guests (See full list)

  • Forum Statistics

    32.1k
    Total Topics
    437.6k
    Total Posts
  • Member Statistics

    26,009
    Total Members
    3,644
    Most Online
    Joseph b
    Newest Member
    Joseph b
    Joined