Roger T Posted February 10, 2011 Report Share Posted February 10, 2011 Since I asked for this forum, I figured I had best contribute to it. Anyway, here is the spline jig that I made a few weeks back. I had found a basic plan on the Web, but could not locate it again, so I have done it in Sketchup. The fence is movable, and is secured with a couple of small clamps. I did not draw the runners for the tablesaw, as each saw is different and uses different measurements for the slots. The jig should be centered between the 2 innermost supports when you attach the runners. I cannot take credit for the design, only the SU drawing. Roger Spline Jig RO.skp Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.