55" fence on my Craftsman Hybrid

[Static_23]

after $60 in material i built my fence into a 55"

[knotscott]

Wow...that's a bunch of rip capacity on both sides. I'd be wanting to fill the space on the right to prevent me from walking into the overhang.

[Static_23]

ya, I'm in the process of designing a router cabinet that will also hold accessories for the table saw as well as the router.

once that is built ill post another picture.

[ssrt3]

Ok what did you get to make the new rail I would like to extend mine, what are you useing for the slide rail on the back side of the saw where it has the foot on the bottom of the fence thanks

[Static_23]

well i used 3" angle and 2"x3" tubing. i had to cut about a 1/2" off on side of the 3" angle. that way it stick up higher than my table. could have used 2.5" angle but i wanted the support of the 3".

for the back foot on the fence i simply removed it. then took a piece of UHMW and cut it to size. made it so that when stuck to the bottom of the fence it would stick up about 1/16" lower than the fence guides. the only problem that i have now is that i cant use the full fence but i am designing a cabinet that will have my router in it and also drawers and cabinet space for blades, bits, and accessories.

one picture shows the piece that i double stick taped to the bottom of the fence and the other shows how far it sticks out.