Skip to content
View in the app

A better way to browse. Learn more.

Wood Talk Online

A full-screen app on your home screen with push notifications, badges and more.

To install this app on iOS and iPadOS
  1. Tap the Share icon in Safari
  2. Scroll the menu and tap Add to Home Screen.
  3. Tap Add in the top-right corner.
To install this app on Android
  1. Tap the 3-dot menu (⋮) in the top-right corner of the browser.
  2. Tap Add to Home screen or Install app.
  3. Confirm by tapping Install.

Airless rigs are easy to clean

Featured Replies

Especially if you are spraying outside.

Turn the tip around, and spray what's in the line back into the can, using water to push waterbourne through. As soon as you see it thinning out, or losing color, stop. A little bit of water won't hurt a thing.

If I'm outside, with the tip turned around, I spray the now thinned down remnants in the hose out of some grass. Stop, and put some clear water in the bucket you are drawing out of, and rinse off the pickup with the hose. Keep spraying until it comes out clear. The stuff on the grass will be gone the next cutting, or second if it's short, never to be seen again.

If you are going to spray again tomorrow, or a few hours later, put plenty of water in the bucket that lets you submerge the gun. Just drop it in until the next coat.

If you're done, suck some Pump Saver through the rig. As soon as it comes out of the gun, the rig is filled. Take the tip out, make sure it's clean under running water, and put it back in. You're set until the next time. I reuse Pump Saver too, if I'm careful enough not to push paint back in the container.  The bottle. has a big enough top, as seen in the picture, that the pickup can go right in the bottle.

If I'm spraying somewhere that it's not okay of spray it out on the grass, I'll run it down a sink, and run plenty of water behind it. A kitchen sink with garbage disposal opening is ideal.

I know people think it's a lot of trouble to clean them, but once you get used to it, it's a whole lot less trouble than using a brush, or roller.

This pump is at least 30 years old.  At some point, I finally figured out to lay an old sheet over it when I'm painting.  You can see how crusted it is with old paint, but the gauge was added after I got smart enough to start covering it.  That plastic box came from Home Depot, and is the ideal setup for an airless rig.  It keeps everything together.  All you have to do is lift the pickup over the low side, and put it into a container.  When it goes back in the box, it goes in the bottle of Pump Saver.  The plastic jar in the back right contains all the different tips.

Primer was slow drying in the humidity, so I decided to wait until tomorrow for the finish coat of paint.  The gun, and pickup are waiting in the bucket until tomorrow.

 

 

IMG_2637.JPG

IMG_2638.JPG

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

Who's Online (See full list)

Forum Statistics

  • Total Topics 32.1k
  • Total Posts 437.6k

Member Statistics

  • 26,010 Total Members
  • 3,644 Most Online
  • Lolli4 Newest Member ·

Account

Navigation

Search

Search

Configure browser push notifications

Chrome (Android)
  1. Tap the lock icon next to the address bar.
  2. Tap Permissions → Notifications.
  3. Adjust your preference.
Chrome (Desktop)
  1. Click the padlock icon in the address bar.
  2. Select Site settings.
  3. Find Notifications and adjust your preference.