Juicegoose Posted April 18, 2011 Report Posted April 18, 2011 I'm needing a 6" flange fitting for my 6" s & D piping. I haven't been able to locate one so far but have seen plenty in sch 80 pvc. Does anyoe know off hand if the I.D. of a sch 80 fitting works with the o.d. of the s & d fitting? Quote
TimV Posted April 18, 2011 Report Posted April 18, 2011 No. They do not fit each other. What do you mean flange fitting? Is this the connection from your DC to the 6" piping? If so, I used a rubber repair boot. Not only did this accommodate the 2 different ID's but it also isolates the vibration of the DC to the piping. Tim Quote
Juicegoose Posted April 18, 2011 Author Report Posted April 18, 2011 Tim thanks for the reply. I will be using the flange between the bottom inlet of my 50-760 dust collector and the top of my pre separator. I was going in enlarge the hole from 5" to 6" attach a flange at the bottom of the collector and top of the seperator and then insert a piece of flex tubing between the two. I could probably use hvac flanges couldn't I? Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.