JBark19087 Posted May 24 Report Posted May 24 New here, hello to all. A few years ago I closed up my complete woodshop as I was finding that I was hardly using it. Burnt out enough to justify the $175/mos rent. Too bad since I had a lot of good machines and a good amount of experience. I brought my hand tools and a few hand power tools to my condo-apartment, hoping I would use them. I like scale modelling (military) and am setting up a work table. I need shelves and cabinets to hold the tools so I thought I would build them. What self respecting woodworker would buy them, right? I thought I would use my Porter Cable jigsaw to cut the lumber and the dovetail tops/bottom to the sides. Long story short; I can't figure out how to put a blade into my Porter Cable 7549 jigsaw. It's a great model, about 30+ years old. I got some blades from ebay and from searches I do elsewhere they seem right. You know when they say you can find ANYTHING on the internet, not a visual on putting the blades in. Can anyone offer a suggestion please. Thanks. Quote
timothywhite Posted May 28 Report Posted May 28 On 5/25/2026 at 5:14 AM, JBark19087 said: New here, hello to all. A few years ago I closed up my complete woodshop as I was finding that I was hardly using it. Burnt out enough to justify the $175/mos rent. Too bad since I had a lot of good machines and a good amount of experience. I brought my hand tools and a few hand power tools to my condo-apartment, hoping I would use them. I like scale modelling (military) and am setting up a work table. I need shelves and cabinets to hold the tools so I thought I would build them. What self respecting woodworker would buy them, right? I thought I would use my Porter Cable jigsaw to cut the lumber and the dovetail tops/bottom to the sides. Long story short; I can't figure out how to put a blade into my Porter Cable 7549 jigsaw. It's a great model, about 30+ years old. I got some blades from ebay and from searches I do elsewhere they seem right. You know when they say you can find ANYTHING on the internet, not a visual on putting the blades in. Can anyone offer a suggestion please. geometry dash online. Thanks. Hello, your Porter-Cable 7549 jigsaw uses a set-screw blade clamp (U-shank blades). I think you should unplug it, loosen the small screw at the front blade holder, slide the blade all the way up with teeth facing forward, then tighten the screw firmly. If it won’t go in, you likely have the wrong blade type (it must be U-shank, not T-shank). 1 Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.