Recommended Posts

Posted

Marc, I am new to woodworking and have a situation. I built the Torsion box table like yours but now i want to incorporate a t-track system from Rockler. my dilemma is that i have already secured the MDF with brads. what are your thoughts on routing through the brads to create the space to insert the t-track. i want the track to be flush with the top of the table since my table is actually an assembly/outfeed table.

Posted

My thoughts are "don't do it". Aside from ruining the bit, metal hitting metal is never safe. But since the table is a gridwork, you should be able to run the t-track adjacent to the line of brads. If you happen to be unlucky and a brad or two is in the way, consider using an old chisel to remove stock round the brad and then yank it out with pliers. When you route, you'll clean up the spot you just mangled with the chisel.

Posted

Thanks for the feedback Marc. Do you think i could just drive the brads on through the mdf with a nail set and then route out the track? I didnt follow your steps to a "t". I have brads going both ways instead of just one so even if i run it offset i would hit brads. Also my grid work is offset as well to keep from having to toenail them.

Posted

Ahh I see. Well, problem that I found with a nail set is that brad nails don't have enough strength for that to work properly. It might work, but the nail tends to bend and buckle since it is so thin and fairly soft. So some may indeed go deep enough, others might just push to the side, and others might compress and crumble. But, with enough taps you should be able to get them deep enough so that they won't be a problem. You'll just do a little more damage to the MDF. But again, you will be routing a channel there so it isn't much of an issue.

Posted

that would make the table even heavier than it already is. although it would solve my problem i dont think i want to add the additional weight.

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Who's Online   1 Member, 0 Anonymous, 41 Guests (See full list)

  • Forum Statistics

    32.1k
    Total Topics
    437.6k
    Total Posts
  • Member Statistics

    26,009
    Total Members
    3,644
    Most Online
    Joseph b
    Newest Member
    Joseph b
    Joined