Skip to content
View in the app

A better way to browse. Learn more.

Wood Talk Online

A full-screen app on your home screen with push notifications, badges and more.

To install this app on iOS and iPadOS
  1. Tap the Share icon in Safari
  2. Scroll the menu and tap Add to Home Screen.
  3. Tap Add in the top-right corner.
To install this app on Android
  1. Tap the 3-dot menu (⋮) in the top-right corner of the browser.
  2. Tap Add to Home screen or Install app.
  3. Confirm by tapping Install.

blotchy beams due to sanding... i think

Featured Replies

To start off with, i have almost no experience with wood apart from what I've recently done with my exposed beams at home.

 

So I've completely stripped the paint off the beams in my kitchen with a belt sander then sanded down to 240 grit with a orbital sander.

After applying some poly I've realised it starting to come up blotchy, did some research and found out applying a diluted version first may help. It did a little but it's still noticeable.

 

Now I've seen pictures and videos on the net of what blotchy wood looks like, and it looks much more natural compared to what I've got in the kitchen. It looks like maybe the belt sander had something to do with it? maybe I was too harsh when using it? 

 

here are some pics

aq07.jpg

0q4p.jpg

Welcome to the group and welcome to the world of woodworking.

 

Sorry to say but it looks like tracks from the belt sander.  It's a very aggressive tool and it takes a lot of practice to use one without causing serious damage that subsequent sanders will be unable to fix.  Unfortunately, there's no fix for this short of starting over.

 

Frankly, though, I wouldn't worry about it.  Your work doesn't look nearly as bad as my first efforts with a belt sander.  I attacked a set of pine shelves with swirling strokes (mistake #1) covered them with a dark pigment stain (mistake #2) and then installed them below eye level (mistake #3).  Your beams are way up above people's heads and won't be scrutinized nearly as closely as you think.

 

Next time you break out the sander, focus on long, overlapping strokes that run the entire length of the board.  It's almost impossible to stop and reverse direction without leaving a divot.

Woody, I would start by using some sixty grit on that orbital and sand it all again. Then go to eighty grit and One twenty grit. For overhead beams, that's as smooth as you need to go. For your first coat of poly, use a wipe on solution that will dry fast and you can see how successful you were. If it requires a little more touch-up, the wipe on sands off easier than a full coat.

+1 on resanding. also looks like you used a gloss poly. something with less sheen would look more natural and won't call as much attention to your sanding marks.

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

Who's Online (See full list)

  • There are no registered users currently online

Forum Statistics

  • Total Topics 32.1k
  • Total Posts 437.6k

Member Statistics

  • 26,010 Total Members
  • 3,644 Most Online
  • Lolli4 Newest Member ·

Account

Navigation

Search

Search

Configure browser push notifications

Chrome (Android)
  1. Tap the lock icon next to the address bar.
  2. Tap Permissions → Notifications.
  3. Adjust your preference.
Chrome (Desktop)
  1. Click the padlock icon in the address bar.
  2. Select Site settings.
  3. Find Notifications and adjust your preference.