Mzdadoc Posted November 5, 2014 Report Posted November 5, 2014 I've got the SD508 set and finally took it out of the package to use them and figured I'd measure the blade thickness and mark my chippers with a silver sharpie. I've got four that measure 3/16, one 1/8, and one 5/32. According to my paperwork I should have a C=1/16 D=3/32 and E=1/8 (Not including the outer blades) Am I missing something or am measuring too precise with my vernier caliper? Quote
Beechwood Chip Posted November 5, 2014 Report Posted November 5, 2014 Just checking - are you measuring the width of the chipper tooth or the plate? Quote
dwacker Posted November 5, 2014 Report Posted November 5, 2014 The chippers overlap an 1/8 carbide tip is not an 1/8 Quote
Mzdadoc Posted November 5, 2014 Author Report Posted November 5, 2014 I'm measuring right at the tooth. I stacked them as directed for 3/4" Ply and it's perfect. PB I do see the overlap now that it's all set up. Thanks guys!!! Sorry for the premature panic!!!! LOL Quote
wouldwurker Posted November 5, 2014 Report Posted November 5, 2014 I have this dado stack too - I'll take some caliper measurements and let you know so you'll at least feel better that your set is complete and correct. (PM me if I forget!) By the way, lessons I learned with this stack: 1.Keep that poster they include with the stack and size combos - I have mine on the wall next to the TS and reference it often 2. Just because you have all the plates doesn't mean you can safely put them all on your TS. Get a good idea for the amount of plates that will safely fit on your (arbor/trunion [i get those mixed up]. I have a PM 2000 and can't fit the whole stack. 3. Use a sacrificial board clamped over the dado insert when making the initial cut through your dado insert 4. If you only have one dado insert, 'open' it up as projects require. I made my hole with the max amount of plates, which I never used again, and now have too much clearance with my dado insert (so I use blue tape) Quote
wouldwurker Posted November 5, 2014 Report Posted November 5, 2014 Oh, and have fun trying to remove each blade from the TS with your fingertips when you switch them out Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.