Popular Post cjtboy Posted May 23, 2017 Popular Post Report Posted May 23, 2017 Been off the forum for a while given a move and work keeping me busy - hope to get back into the woodworking swing again. Anyway, that is not what this post is about. It is specific to my Laguna bandsaw (14bx) but could be about any tool really. My bandsaw started to shake pretty bad on startup about 8-9 months ago. This was after maybe 6 months of use (bought new). The shaking was pretty bad at startup and power down - kind of when it hit the right frequency it would go nuts. Then once up to speed it was way better, but not as good as when I first got it. I thought maybe it was a blade getting bent out of shape or something and mostly ignored it as cut quality was still great (it didn't shake when I removed blade and started it up). I did also shim one of the rubber feet a little to make sure it wasn't an uneven floor (cement garage). I finally got around to ordering a new blade thinking all would be good and had the exact same issue... so I scoured the web looking for all the potential issues of vibrations in bandsaws - which is one deep rabbit hole if you're interested! I had a long list of items to check out and/or replace: balance to wheels, clean or replace tires, check for coplanar, etc. Thankfully I didn't end up replacing a bunch of things, but spent a lot of time fussing around to no avail. Just a few months ago, I started getting a nasty rotational clunking sound. Curses! I called up Laguna and was on the phone with their tech on and off for a week trying to trouble shoot. Turns out the bolts holding the lower wheel hub and brake disc (behind the lower wheel) had worked themselves very loose and the hub was wobbling significantly as a result. Of course I thought this was the cause of my issues all along and took all apart to clean it up, get some loctite in there to hold the bolts in place and put all back together. Crossed my finger, turned it on and... still shaking like a crackhead on startup and shut down just like before. Blast! So yesterday I finally figured it out. All along it was the 2 wheel bracket section of the mobile base, which gets mounted to the front bottom of this saw with two bolts each in an adjustable slot. The bolt on the right had loosened just enough for the bracket to slip down and sit unevenly, which created a similar effect to the saw sitting on a twisted board. I only figured this out by dumb luck - I was moving it around yesterday and thought it was more unstable than it should be - even with a small shim I couldn't get it to sit nicely. Before thinking to check the bracket, I actually was thinking the metal base had a twist and this was the issue! yeah right. Nope, all I had to do was level out that bracket and tighten down. Saw is like new again. Such a simple fix that I wish I had thought about originally - not exactly proud at how long this took me to figure out. These past few months I was even thinking of getting rid of it at some point given for me working on tools < woodworking, big time, especially when I don't get nearly the amount of shop time I would like. Anyway, wanted to post in case anyone else had similar issues and also just as a reminder to check out all the easy fixes before digging into more complex ones or diving down the internet rabbit hole trying to trouble shoot - it could be dead simple. 3 Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.