Munson Posted February 6, 2012 Report Posted February 6, 2012 Well hello guys, this is my first post, but I've been here lurking for awhile. I was looking for a little help with tool setup. Recently my father, a devoted woodworker, purchased the Powermatic 8" jointer with the helical cutting head. This was very good for me since I became the recipient of his old Rockwell/Delta 8" jointer that has served him well since 1983. I should be getting that in my shop if the rain stays away tomorrow. Anywho, in setting up his new jointer, we noticed that we were getting snipe on the last 3" of the board. It was a pretty significant, so we began adjusting the outfeed table to fix it. The only way we can get it to be at an acceptable level is by raising the outfeed table all the way to its max limit, its completely topped out. This is not at all what we have had to do on past jointers and was wondering if this was normal due to the parallelogram nature of the machine or something about using the helical cutting heads, both of which are new to us. Thanks in advance for the help. Quote
Torch02 Posted February 6, 2012 Report Posted February 6, 2012 That doesn't sound right - the outfeed table should be in plane with the very top of the HH cutters (check with several of them). If that is true, then that makes me wonder if you technique is proper, maintaining downward pressure (throughout the cut) just left of the cutters on the outfeed table. Quote
jshoey Posted February 6, 2012 Report Posted February 6, 2012 Sounds like the far end of the out feed table is too high (or the cutter head end of the out feed table is too low). Quote
dwacker Posted February 6, 2012 Report Posted February 6, 2012 Mark did a video that is really helpful. I have the 12" and the table is not even close to maxed out to be level with the cutters. Don Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.