Pbmaster11 Posted March 2, 2012 Report Posted March 2, 2012 So i was in the shop all day... table saw working fine. One cut later and the blade is out of alignment... I could tell because the blade was pinching the cut... took me forever to get it back to tuned conditioned... had to loosen trunions (spell check) and the only way to do that was a tedious process. No idea how it could have gotten out of alignment, but got it fixed! Quote
dwacker Posted March 3, 2012 Report Posted March 3, 2012 What kind of saw are you using? Most use a flat washer with a cut lock washer. Take the cut lock washers out and install star washers so it doesn't happen again. Don Quote
Pbmaster11 Posted March 3, 2012 Author Report Posted March 3, 2012 Rockwell contractors saw. Good little saw. After my current project I am going to go through it again and make it solid. Star washers... check! Thanks for the help wacker. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.