bazzzman Posted May 28, 2012 Report Posted May 28, 2012 I just brought home a new DW734 planer and have a question about setting it up. The Manual isn't very clear about leveling the infeed and outfeed tables. The manual shows a small diagram that has a level going from the bed of the planer to the outer side of the infeed table, with a gap in between the bed and table. With the bubble in the center, so guessing that is how it should be..just bumpt the wood when it enters the bed area . Does that go for that outfeed side as well? I waxed the tables bed and cleaned the rollers off, is there anything else I need to do before I try to plane my first boards? Thanks in advance for any info Quote
wleingang Posted May 29, 2012 Report Posted May 29, 2012 I have the same planer. Yes just use a level or two flat boards to make sure the top of the wings are in line with the top of the planer surface. Quote
wleingang Posted May 29, 2012 Report Posted May 29, 2012 Sorry I actually have the dw735. But the wings would be aligned the same way. Quote
bazzzman Posted May 29, 2012 Author Report Posted May 29, 2012 Thanks Will for the fast responce, now just need to wait for my Bell Forest delivery. Quote
bazzzman Posted May 31, 2012 Author Report Posted May 31, 2012 Glad I bought some boards to practice on first. I am getting about 2" of snipe on the front and rear of the boards, guess I need to recheck my tables again. I was taking very little off at the time also..maybe 1/64th. On the brightside the dust collection was great I barely had anything to clean up ) Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.