Recommended Posts

Posted

I just recent purchased a new PM2000 and was going through the table saw tuneup procedure that is posted on The Woodwhisperer. I was checking the alignment of the fence to the miter slot with a dial indicator when I discovered that there was a lot of variation throughout the face of the fence as I slid along miter slot. The plastic face does not appear to be perfectly flat. I get as much as .007 movement in certain sections of the fence face.

Is this normal? I'm I being too picky? Do I have a defective fence?

Posted

Do you see the same .007" deviation when you stop moving the dial indicator and just take measurements at various points along the fence?

-- Russ

Posted

I find that the plastic fences all do this and it is perfectly normal. You will most likely find that the fence is straight, but has a slight dip in the vicinity of each bolt. Most of the time, the dip is only spans an inch or two so it doesn't usually impact most work. My fence is like this and I don't even think about it anymore.

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Who's Online   1 Member, 0 Anonymous, 66 Guests (See full list)

  • Forum Statistics

    32.1k
    Total Topics
    437.6k
    Total Posts
  • Member Statistics

    26,009
    Total Members
    3,644
    Most Online
    Joseph b
    Newest Member
    Joseph b
    Joined