Skip to content
View in the app

A better way to browse. Learn more.

Wood Talk Online

A full-screen app on your home screen with push notifications, badges and more.

To install this app on iOS and iPadOS
  1. Tap the Share icon in Safari
  2. Scroll the menu and tap Add to Home Screen.
  3. Tap Add in the top-right corner.
To install this app on Android
  1. Tap the 3-dot menu (⋮) in the top-right corner of the browser.
  2. Tap Add to Home screen or Install app.
  3. Confirm by tapping Install.

Sanding between coats

Featured Replies

I'm using a spray system for the first time. Applying two coats of an oil based stain followed by a water based poly. My question is: do I need to Sand between all coats? I am going to apply the second stain today. Should I do a light sanding first ? If so, what grit?

When i start applying the poly, do I need to sand between all coats? I figure it will take 4 or 5 coats of poly.

Adam

Sand between coats of stain will remove color (you probably already knew that, just covering the bases :) ) so that's not a good idea. When I spray a stain, its just a quicker way of delivering the stain to the project. It still gets wiped back just like hand applying a stain.

Before applying the water-based poly...make sure the stain has completely dried. I would give it a week, thats just me. The more porous the wood the longer due to the stain has to gas back through the surface of the wood, porous woods pull the stain deep down.

Yes a very light sand between all coats of water-based finish. But since you're new to spraying, most tend to spray Topcoats to thin for fear of runs. So in your case try scuff sanding with 320 AFTER your second coat to prevent sandthrough to your color. Midcoat sanding gives the finish something to hold onto, also levels any uneven areas.

Hope this helps.

-Ace-

Edited for clarity my bad sorry. :wub:

  • Author

I think I am a bit confused. You say dont Sand but sand. Did you mean, don't sand between stain coats, but sand between poly coats?

I didn't spray stain thin...over sprayed, but wiped down a few minutes later.

If I read your po

Sorry for the confusion. Thought you were spraying stain and topcoat and want to know if you sand "all" coats including stain. :)

1. Stain - don't sand the stain, it removes color - you already knew that!

2. Topcoat - sand after the second coat for the reason's I stated above. Reason being, you will basically be cutting into the first coat by first beginning your sand on the second coat, make sense? When you sand your removing finish, perhaps as much as 1/3 of a coat you laid down, it all depends. Stay away from the edges till you get sufficient amount of finish laid down.

-Ace-

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

Forum Statistics

  • Total Topics 32.1k
  • Total Posts 437.6k

Member Statistics

  • 26,009 Total Members
  • 3,644 Most Online
  • Joseph b Newest Member ·

Account

Navigation

Search

Search

Configure browser push notifications

Chrome (Android)
  1. Tap the lock icon next to the address bar.
  2. Tap Permissions → Notifications.
  3. Adjust your preference.
Chrome (Desktop)
  1. Click the padlock icon in the address bar.
  2. Select Site settings.
  3. Find Notifications and adjust your preference.