WoodNoob Posted November 19, 2012 Report Posted November 19, 2012 Hi all, I just spent an hour and a half calibrating my cabinet saw, checking blade is 90º to the table top, parallel to the mitre slot, and parallel to the fence, and the fence parallel to the same mitre slot. Then I ripped a bunch of very thin strips of wood. (very hard wood -ironbark if you need to know-, at 70mm - the full height of my blade, I had to feed very slowly) All of the strips are slightly thicker on one edge than the other! Argh! Unfortunately I didn't notice until I'd done the lot, so I can't be sure if it was the top edge or the bottom edge. Duh. Is this because I've ripped something so dense and at the full capacity of the blade that it's just naturally deflected the blade off perpendicular to the table? Or is there something wrong with my setup? If it's deflection, is there something I can do about it, other than get a bigger more powerful table saw? A better blade maybe? Quote
Eric. Posted November 19, 2012 Report Posted November 19, 2012 Full kerf blade or thin kerf? Good blade or garbage blade that came with your saw? You didn't mention if you checked that your fence is 90* to the table. Is your ZCl plate dead flush with your table? Quote
WoodNoob Posted November 19, 2012 Author Report Posted November 19, 2012 Thanks Eric. Well I'm about to go buy a new blade, so fingers crossed. Zci is flush. I made sure of that. I didn't think to check fence is perp to tabletop! Ill have to check that too. Thanks Quote
Rick LoDico Posted November 19, 2012 Report Posted November 19, 2012 Did you joint the wood first? Face then edge? Quote
WoodNoob Posted November 20, 2012 Author Report Posted November 20, 2012 Hi Rick, I jointed as well I could without a jointer, and my hand plane elsewhere. I did thin slices on the tablesaw using known flat edges. That is probably contributing. I did however just come back with a brand new CMT thin kerf 42 tooth. It made a world of difference. Both because of the sharpness, tooth count, and thinner kerf. It ripped through the hardwood almost like it was pine. My were a lot better. However, when checking the fence, I did find it was off vertical by a point of a degree. It was sitting about 90.1* It's an Align-A-Rip, and I suspect not a great one, as whenever I lock it down I have to run a square up the mitre slot to check that the front and back ends are the same distance away. Drives me a bit bananas. So anyway, there's no adjustments to be able to make for tilt. So I backed off the screws that attach it to rail slide and shimmed one side and screwed it back in. It has made it better, but still not perfect. Guess I might have to save up for a better fence. Quote
Rick LoDico Posted November 21, 2012 Report Posted November 21, 2012 The fence should be 90 to the table but completely essential. The impotent 90 is the side that rides on the table and the side or edge that is being cut. If that angle is, say, 88º, then you'll get one edge thicker than the other. Quote
WoodNoob Posted November 21, 2012 Author Report Posted November 21, 2012 Yeah - the face that the wood rides against wasn't 90 to the table. Of course for thinner stock like sheet goods this doesn't really matter. But when cutting deep thin strips it becomes really obvious. (These are strips for bent lamination) Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.