Skip to content
View in the app

A better way to browse. Learn more.

Wood Talk Online

A full-screen app on your home screen with push notifications, badges and more.

To install this app on iOS and iPadOS
  1. Tap the Share icon in Safari
  2. Scroll the menu and tap Add to Home Screen.
  3. Tap Add in the top-right corner.
To install this app on Android
  1. Tap the 3-dot menu (⋮) in the top-right corner of the browser.
  2. Tap Add to Home screen or Install app.
  3. Confirm by tapping Install.

Planing and jointing for the first time with dust collection

Featured Replies

It has been long overdue for me to add some sort of dust collection to my planer and jointer. The apparatus I have on the jointer works perfectly, so I will keep it, but the planer needs some work.

I have an older model Delta bench top jointer with a dust "ejection chute" on the side. No place to plug in a hose. So I made a piece out of 0.25" MDF to fit firmly over the port and seal off as much air flow as possible. Here is the picture:

photo2.jpg

Here is a picture of what my shop looks like after jointing one face and one edge of 20BF of 4/4 Maple:

photo1.jpg

As you can see, there is practically no shavings on the floor :) Makes me a happy camper because the hose or chute never clogged up once.

Now, here is the start of adding a dust collection to my planer. I drilled through the shroud that covered the dust cover and attached my wide shop vac hose attachment with some screws. I tried to get the hose as much in the middle as possible to even out the distribution of vacuum power. I did not want to seal off the whole shroud because I was unsure if my vacuum could handle this much dust/shavings.

To my surprise, it handled it very well. As you can see in the following picture, this is my planer after I planed the 4/4 maple down to 3/4 thickness. The small amount of dust on the ground is what would slip out the sides out of the suction of the vacuum. But, it's better than the two garbage bags that were filled up from dumping the vacuum when it was full. I am confident that I could enclose the entire port and use my shop vac on this particular planer.

photo.jpg

try puting some kind of filler on you mdf that way you will have a seal up against your metal. maybe glue on some rubber will help create a better seal.

  • Author

try puting some kind of filler on you mdf that way you will have a seal up against your metal. maybe glue on some rubber will help create a better seal.

I found some foam tape that I am going to give a try.

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

Who's Online (See full list)

  • There are no registered users currently online

Forum Statistics

  • Total Topics 32.1k
  • Total Posts 437.6k

Member Statistics

  • 26,010 Total Members
  • 3,644 Most Online
  • Lolli4 Newest Member ·

Account

Navigation

Search

Search

Configure browser push notifications

Chrome (Android)
  1. Tap the lock icon next to the address bar.
  2. Tap Permissions → Notifications.
  3. Adjust your preference.
Chrome (Desktop)
  1. Click the padlock icon in the address bar.
  2. Select Site settings.
  3. Find Notifications and adjust your preference.