haysflooring Posted February 3, 2013 Report Posted February 3, 2013 I'm going to go pick up rockwell delta unisaw next week the motor says it's 1 1/2 hp 12/220 volts. he has a 3 hp he will put on it if i what. My question is is the motor the only difference on the older unisaws for a 1 1/2 hp Saw verus a 3 hp saw and will they interchange . he says the 1 1/2 motor runs good. Would that be good for ripping 2" white oak and walnut? Quote
pghmyn Posted February 3, 2013 Report Posted February 3, 2013 Not from experience, but from a general consensus on here, I think it would be recommended to go with a 3hp motor in your case. Quote
haysflooring Posted February 3, 2013 Author Report Posted February 3, 2013 I have never used a unisaw before that i can remember, but i always wanted one. I have a 1 1/2 hp 113 series craftsman now in my home shop now so even a 1 1/2 hp unisaw would be a upgrade. And for the price I'm going to buy it anyway. But I would like to know can you put a 3 hp motor on a older unisaw? Was the basic saw the same just the motors different? I hope I am making sense here. Quote
dwacker Posted February 3, 2013 Report Posted February 3, 2013 Depends on the age. The old repulsion motors had more torque than the capacitor motors twice their size. Comparing a 1.5 capacitor motor to a 3 hp capacitor is night and day. On the other hand the 1.5 repulsion is going to out perform the 3hp capacitor motor. Look at the motor if the 1.5 is sort of bullet shaped and works well then I'd just stick with it. If its not then I'd go up to 3 hp, the frame size will be the same. Don Quote
haysflooring Posted February 3, 2013 Author Report Posted February 3, 2013 Thanks. Thats the answer I was hoping for. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.