Tpt life Posted February 21, 2013 Report Posted February 21, 2013 I just invested in my first tenon jig. My table saw is old enough to not possess a T-slot miter channel. How much of a safety concern is using this jig without a hold-down capability? Quote
adambaum Posted February 22, 2013 Report Posted February 22, 2013 Can you explain your setup a bit? Most tenon jigs have a miter bar attached to them. Did you remove it from your jig? In general, I would be concerned. A main purpose of the miter bar/slot is to ensure that you and your work piece travel in a straight line. Any lateral movement could cause kickback and other messiness. I guess you could use your fence in that regard, but I still think there is the potential for movement in an unintended direction. Have you tried building your own jig that straddles your fence? As long as the fence is aligned accurately, you'll travel in straight line and it also prevents lateral motion. I've used one for years without issues. adam Quote
Tpt life Posted February 22, 2013 Author Report Posted February 22, 2013 The table has left and right slots. Both slots are square 3/4 by 3/8. The jig came with "washers" screwed to the jig runner that would provide hold-down in miter slots that are T shaped with the bottom 3/16 of the slot being approximately 3/16 wider on either side of 3/4. I have no concern about the jig traveling parallel to the blade and I am not talking about removing the runner from the jig. I am more wondering if there is any hazard of back to front tipping when making cheek cuts on taller pieces if I remove the "washers." Is this a better description? Quote
nikbrown Posted February 22, 2013 Report Posted February 22, 2013 You are fine! The T-slot isn't nessicary for something as heavy as a tenon jig. As long as it can ride in the miter slot you are fine. Quote
Tpt life Posted February 22, 2013 Author Report Posted February 22, 2013 Thank you for the replies. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.