Recommended Posts

Posted

I have a jet jbm-5 bench top mortiser that came with Jet 1/4, 3/8, and 1/2 mortising bit and chisel. I unpackaged the 1/2 bit and when I installed it, the bit is approximately 1/2 bellow the bottom of the chisel. It's pushed up all the way in the chuck. It appears that on the smaller bits, the shank of the bit goes through a hole at the top of the chuck, but the hole is not big enough for the 1/2 bit. The instructions say that it will accept up to a 1/2 chisel bit and the bit came with it. Am I missing something?

Posted

I pulled the chisel down, but the force pushes back up against the bushing. The mortiser was a Craigslist buy, so I'm guessing the chuck isn't stock. For now, I cut the end off the bit. I probably end up ordering a new chuck from jet.

Posted

Im sorry I forgot to get back to you.

My door stop is the exact same way. Look in side and verify that the extension is not on the spindle. Otherwise cutting off was your only real option.

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Who's Online   1 Member, 0 Anonymous, 43 Guests (See full list)

  • Forum Statistics

    32.1k
    Total Topics
    437.6k
    Total Posts
  • Member Statistics

    26,009
    Total Members
    3,644
    Most Online
    Joseph b
    Newest Member
    Joseph b
    Joined