Daniel Kuehl Posted April 20, 2013 Report Posted April 20, 2013 How long does a router bit bearing last for everybody. I have a Bosch flushtrim bit that seized up on me in less than a year. I've never cleaned it, but never really used it "too much". I really only tinker in the shop on the weekends. I used the bit on red oak and plywood mostly. Never did clean it either. Is there a way to make these bearing last longer? Quote
Dave's Not Here Posted April 20, 2013 Report Posted April 20, 2013 Cleaning is a good idea and so is a drop of bearing lube every so often. Quote
wdwerker Posted April 20, 2013 Report Posted April 20, 2013 Every time I see any pitch or resin on my bit I clean it and the bearing then put on a couple of drops of bearing lube. I will usually lube the bearing any time I change the bit as well. Quote
dwacker Posted April 21, 2013 Report Posted April 21, 2013 I don't take care of mine at all. I use alot of preglued edge banding and the bit is usually shot after about 500 ft. I'm sure if I cleaned them properly they would last longer. Quote
Daniel Kuehl Posted April 21, 2013 Author Report Posted April 21, 2013 I was kinda thinking it was due to my own laziness... Going to add "self-cleaning bearings" to my list of things to invent someday. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.