Recommended Posts

Posted

Here's one I've been pondering over. My bandsaw has two fixed speeds, 330 metres/minute and 800 metres/minute. That equates in English to 1082 feet per minute to 2664 feet per minute.

I have never changed the speed from the slowest speed (1082) and I've put all sorts of blades into the saw (1/4" up to 5/8" with many different tooth patterns).

I only ever cut hard and softwoods with this and occasional hardwood ply. Never cut MDF with it.

 

Does anybody know what sort of speeds work best with, say, a 1/4" (0.014" thick) 6TPI blade or a 1/2" (0.025" thick) 3TPI?

I don't use premium blades BTW just regular high carbon steel ones. I also realise that the faster the speed the easier it can be to slip up and lose a finger. I'm also never really cutting anything thicker than about 6 inches (rarely) and most of the time  I cut less than 2 1/2" thick stock and don't currently get any burning.

 

I've seen all sort of bandsaw blade calculators on the internet and they seem to refer to metal cutting blades  :wacko:

As usual the blade manufacturers and bandsaw manufacturer have instructions in all languages but nothing about preferred speeds.

Posted

In responding to this question I will be openly admit to something very embarrassing.

 

I have a 17" Grizzly bandsaw. Some other woodworkers that have the same one and others that were considering it started a conversation on the bandsaw. One of the questions posed to me was which speed did I run it at? 

 

I thought they must be mistaken since mine only has one speed. I had to go out to the shop and open the lower cabinet to confirm that, yes in fact, it did have two speeds. I have run everything from a 1/4" up to 1" blade on my bandsaw, never changed the speed, and have had great results. So I have had the saw for 7 years and never even knew that it had 2 speeds!

 

I have been putting out high-end work for years with this method (of operating in complete ignorance) so I figure if it works, why would I bother doing it any different?

 

I also use the high carbon blades, nothing fancy but they work. 

 

 

 

post-1719-0-44478700-1367346483_thumb.jp

Posted

"There is also a minimum speed you should run a band saw blade. (EXAMPLE: Timber Wolf® band SAW blades should not run under 2,400 S.F.P.M."

 

This applies to most high carbon blades. Spring steel blades run at slow speeds. A 17" saw should be running at 3800 which is why the high speed on Grizzly saw 17" is 3500. A 24" at 4000 and of course why my PM runs at 4000. The smaller saws seem to have no reasoning as to why they set the speeds where they did.

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Who's Online   1 Member, 0 Anonymous, 35 Guests (See full list)

  • Forum Statistics

    32.1k
    Total Topics
    437.6k
    Total Posts
  • Member Statistics

    26,009
    Total Members
    3,644
    Most Online
    Joseph b
    Newest Member
    Joseph b
    Joined