lionmane45 Posted June 25, 2013 Report Posted June 25, 2013 Hi all, I've been around these forums for quite a while - reading, but never posting. I decided to change that and I hope to become more involved with this great community. I just wanted to introduce myself as well as show a little website I made. It's a simple Board Foot Calculator - nothing that hasn't been done before, but most of the calculators I've seen online are ugly or not very customizable. I had fun creating this little thing. If you try it out, I'd love to hear your feedback, good or bad! http://bfcalc.com Quote
wdwerker Posted June 25, 2013 Report Posted June 25, 2013 Not sure I like the waste option. I just run the math on my pocket calculator in the shop, or at the hardwood mill I have been using for years. The board ft in a plank is figured before they straight line rip it . And it is done with an estimating stick with a chart. A 12 3/4" wide 8/4 piece of poplar 12 ft long S2S with one edge straight line ripped was 28 board ft. So it was approximately 14" wide before it was ripped. I figure the number of parts I can roughly fit on a plank and buy some extra for a safe margin. Big parts can leave a higher level of waste depending on the size of the boards available. Quote
CessnaPilotBarry Posted June 26, 2013 Report Posted June 26, 2013 Big parts can leave a higher level of waste depending on the size of the boards available. On higher quality projects, it's not just big parts that can have a lot of waste. For example, I often start with 12 or 16 quarter stock for legs, with the initial cuts being diagonal bevel rips to realign the grain on all four corners of the part. It's not unusual for a cabriole leg to be 75% waste. On other 4/4 frame and door parts, it's really nice to align the grain to the board. Calculators can be handy for cabinets and built-ins, though... I like the versions that allow you to build a spreadsheet-like grid, with qty, WxLxT, material choice, and a subtotal for each material. Quote
TRBaker Posted June 26, 2013 Report Posted June 26, 2013 Cool!! Thanks for sharing dbauer. It works real easy, but I couldn't get it to accept a decimal point. Quote
lionmane45 Posted June 27, 2013 Author Report Posted June 27, 2013 Cool!! Thanks for sharing dbauer. It works real easy, but I couldn't get it to accept a decimal point. Thanks for the input! That totally slipped my brain. I updated it so now it will accept decimals (up to hundredths). Eventually I'd like to accept decimals or fractions. Thanks again for the heads up and I'm glad you like it. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.