Skip to content
View in the app

A better way to browse. Learn more.

Woodworking Forums & Project Advice | Wood Talk Online

A full-screen app on your home screen with push notifications, badges and more.

To install this app on iOS and iPadOS
  1. Tap the Share icon in Safari
  2. Scroll the menu and tap Add to Home Screen.
  3. Tap Add in the top-right corner.
To install this app on Android
  1. Tap the 3-dot menu (⋮) in the top-right corner of the browser.
  2. Tap Add to Home screen or Install app.
  3. Confirm by tapping Install.

Butternut Veneer

Featured Replies

I'm considering making new slab front drawers and doors for the kitchen and was looking at butternut. I know the wood itself is quite soft but would I be correct in assuming that using a veneer over plywood would eliminate most of the issues with dings and dents?

It's still going to be soft and scratches and what I call compression dents (where something rubs and leaves a compressed mark)

But Butternut is a lovely wood to work with when it's available. We rarely see it in Atlanta unless you seek it out in specialty sources.

  • Author

It's still going to be soft and scratches and what I call compression dents (where something rubs and leaves a compressed mark)

But Butternut is a lovely wood to work with when it's available. We rarely see it in Atlanta unless you seek it out in specialty sources.

 

Is there any finish that would penetrate the veneer and make it harder?

I am sure there is . A lot would depend on your equipment and skill levels. I use a pre cat water bourne finish but it is only sold to pro shops. Check with your finish supplier. There are post catalyzed products that you have to mix before spraying and they have a limited life before it will harden in your gun.

There are conversion varnishes and epoxy finishes but I have little knowledge of them. You might try posting a question in the finish area.

  • Author

Thanks Steve.

 

The only spraying I've done is a can of poly of lacquer from the hardware store.It might be time to add a new skill to my finishing repertoire.

I am not sure of the process of using epoxy. Triple H and Boatworks know a lot about epoxy. West Systems gets mentioned a lot but they have many types. I know Boatworks uses epoxy on boat components and then sands and topcoats with varnish I think.

Is there any finish that would penetrate the veneer and make it harder?

 

When you use a soft wood over a hard sub straight you get the benefits of the sub straight. This assumes your using thin commercially cut veneer. The hard glue line is going to penetrate the veneer and the finish is going to penetrate the other side hopefully meeting somewhere in the middle. Butternut veneer is a popular cabinet species.

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

Forum Statistics

  • Total Topics 32.1k
  • Total Posts 437.6k

Member Statistics

  • 26,011 Total Members
  • 3,644 Most Online
  • bobtjanitor Newest Member ·

Account

Navigation

Search

Search

Configure browser push notifications

Chrome (Android)
  1. Tap the lock icon next to the address bar.
  2. Tap Permissions → Notifications.
  3. Adjust your preference.
Chrome (Desktop)
  1. Click the padlock icon in the address bar.
  2. Select Site settings.
  3. Find Notifications and adjust your preference.