vicbyrd Posted February 3, 2015 Report Posted February 3, 2015 My Jessm router lift has been doing a good job for over 7 years. I occassionally remove it from the table, where it is enclosed for dust collection, and use compressed air to blow out the router housing and lube the threads with graphite. Lately the crank has been harder to turn, up or down. Is there a good way to ensure the sealed bearings haven't been contaminated with crud? I was thinking of flushing the threads/bearing with mineral spirits and re-lubing. Any suggestions? Thanks Victor Quote
Tom Cancelleri Posted February 3, 2015 Report Posted February 3, 2015 Victor, Welcome to the forums. My bandsaw bearing get caked up with fine saw dust all the time. I use a citrus bearing cleaner from when I played roller hockey. After that I soak my bearings in a dry lubricant, take them out and place them on a paper towel to let the lubricant dry before placing back on my bandsaw. Works great until the next cleaning. Quote
wdwerker Posted February 3, 2015 Report Posted February 3, 2015 I use Bostik bearing lube and let it dry before using. I think it's Teflon like stuff. 1 Quote
CessnaPilotBarry Posted February 3, 2015 Report Posted February 3, 2015 I use a toothbrush and compressed air to clean, and a dry lube like Steve mentioned to lube the threads. Wet and sticky lubes just attract more crap. Even though magazines always seem to mention "old toothbrushes", (pantyhose, too!) I use new ones from the Dollar Store and throw my old ones in the trash... Quote
vicbyrd Posted February 4, 2015 Author Report Posted February 4, 2015 Thanks for all the replies! I've got some Teflon "like" stuff so I'll give that a shot and report back on the results. Quote
Tom Cancelleri Posted February 4, 2015 Report Posted February 4, 2015 A trunnion cleaner and lubricant would be good for the threads. It leaves a dry polymer lubricant on the threads, and acts as a lubricant. I use this on my table saw trunnions and it keeps them nice and smooth. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.