JohnnyNoName Posted December 2, 2010 Report Posted December 2, 2010 Hello all - I need to drill some 15/32" holes in my cast iron tablesaw wing so I can mount a router table onto it. The problem is, I don't have a 15/32" drill bit for metal. Any recommendations as to where and what to buy? Thanks in advance, Jonathan ================================================ Quote
Dan S Posted December 2, 2010 Report Posted December 2, 2010 For that number of holes, go to your local BORG, and get the cheapest bit rated for metal. I'm assuming your going to be using a had drill? Hello all - I need to drill some 15/32" holes in my cast iron tablesaw wing so I can mount a router table onto it. The problem is, I don't have a 15/32" drill bit for metal. Any recommendations as to where and what to buy? Thanks in advance, Jonathan ================================================ Quote
kentuckybill Posted December 2, 2010 Report Posted December 2, 2010 No special bit is required for driling cast. Drill a pilot hole first then follow up with a cheap bit from Lowes. It should drill fairly easy. Good Luck Quote
JohnnyNoName Posted December 2, 2010 Author Report Posted December 2, 2010 For that number of holes, go to your local BORG, and get the cheapest bit rated for metal. I'm assuming your going to be using a had drill? Dan - Yeah, I tried that. But Home Depot, Lowes and Sears only sold the size I need as part of a set, and not individually. Grrr... Jonathan ================================================ Quote
dryhter Posted December 2, 2010 Report Posted December 2, 2010 Hello all - I need to drill some 15/32" holes in my cast iron tablesaw wing so I can mount a router table onto it. The problem is, I don't have a 15/32" drill bit for metal. Any recommendations as to where and what to buy? Thanks in advance, Jonathan ================================================ HERE or HERE Quote
Dan S Posted December 2, 2010 Report Posted December 2, 2010 try a HF set $16.95 http://www.harborfreight.com/29-piece-high-speed-steel-drill-bit-set-32925.html Quote
Ben@FineWoodworking Posted December 3, 2010 Report Posted December 3, 2010 I actually found that my auto zone had a better selection of drill bits these days. Cheaper too. Quote
JohnnyNoName Posted December 3, 2010 Author Report Posted December 3, 2010 HERE or HERE McMaster and/or Grainger. Of course! Thanks. Jonathan ================================== Quote
JohnnyNoName Posted December 3, 2010 Author Report Posted December 3, 2010 I actually found that my auto zone had a better selection of drill bits these days. Cheaper too. Autozone... I'll have to remember that one. Thanks. Jonathan ========================================= Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.