spereira Posted December 9, 2015 Report Posted December 9, 2015 Hello,I recently bought my first table saw. It's a small one but I think not in the low end. At least here in Argentina, where I live.Reading the manual, it says that it can work with a dado blade, and states: Do not attempt to stack dado blades thicker than 13/16" (20 mm). Do NOT use adjustable or wobble type dadoes. Do not use dado blades larger than 6" (152.4 mm) diameter. The maximum dado cut width is 1/2" (12.7 mm).Does anybody have experience with this saw and dado blades? There is a couple of things on that statement that I'm not quite sure, such as what is an adjustable dado blade or is it there a dado blade that is not adjustable? that got me confused.The table saw is this one:Thank you very much Quote
xxdabroxx Posted December 9, 2015 Report Posted December 9, 2015 There are dial a width dado blades available, it means you can only use the stacking kind. 1 Quote
shaneymack Posted December 9, 2015 Report Posted December 9, 2015 This is the kind you cannot use http://www.freudtools.com/index.php/products/product/SD608This is what they recommend http://www.amazon.ca/Freud-SD206-6-Inch-Professional-Dado/dp/B0000223O8 Sent from my SGH-I337M using Tapatalk 1 Quote
spereira Posted December 9, 2015 Author Report Posted December 9, 2015 Thank you very much!!On a side note, the manual also states that the provided insert (I assume they mean throat plate?) cannot be used, as expected for the blade kerf. I haven't been able to find any of those, and since this saw doesn't have the commonly used insert (the one with curves), I wonder if can be built. I guess the challenge is how to make it stay in place.The one that the table has is attached.Thank you all again for the quick response, it helps a lot. Quote
shaneymack Posted December 9, 2015 Report Posted December 9, 2015 Thank you very much!!On a side note, the manual also states that the provided insert (I assume they mean throat plate?) cannot be used, as expected for the blade kerf. I haven't been able to find any of those, and since this saw doesn't have the commonly used insert (the one with curves), I wonder if can be built. I guess the challenge is how to make it stay in place.The one that the table has is attached.Thank you all again for the quick response, it helps a lot. Make a zero clearance dado blade insert. https://youtu.be/Jgh1Hqg1LY8 Sent from my SGH-I337M using Tapatalk Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.