rick Posted June 7, 2016 Report Posted June 7, 2016 We have the Roybi AP-12 planer and it was working well but now the blades aren't shaving the wood and the back guide stops the wood from going through the planer. What can I do to remedy this problem??? It seems to me that the blades are higher than the guide. Quote
..Kev Posted June 7, 2016 Report Posted June 7, 2016 Welcome to the forums Rick! I moved your topic here. I'm sure someone familiar with that planer will chime in on your issue. 1 Quote
wdwerker Posted June 8, 2016 Report Posted June 8, 2016 I have an AP-10 planer. The blades are installed in a holder using a plastic jig that came with machine. The sharp edge is against a stop and the bottom edge of the holder fits in a notch in the jig, then tighten the screws. The blade in the holder is bolted to the head in the planer. The planer head has a pin that slides in a diagonal hole to keep the head still while you bolt in the blade/holder. 1 Quote
rick Posted June 8, 2016 Author Report Posted June 8, 2016 Thank you for your response wdwerker. The problem started before I turned the blades to put the sharp side to use. We got the planer used and there was no jig like you explained but the blade holder has slots and pins so you can't put the blade in wrong and I put the new side in exactly the same way as I took them out. As I said earlier it seems to me that the blades are higher than the back guide and I just don't know what to do to fix it. BTW this problem started just before I turned the blades which is why I turned them thinking they were to dull to work. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.