Bonesandstones65 Posted July 25, 2016 Report Posted July 25, 2016 Hello! I have the subject table saw and she quit on me recently, won't run. When she stopped, I thought the problem was the joemex breaker so I replaced it. The saw ran but produced a lot of "blue light" so I shut her off and now she won't run again. Is it possible I got the breaker connections backwards? I've since replaced the on/off switch but again, no joy... The motor has no reset switch that I can locate, nor a start capacitor that I can see. Perhaps one might be under the black housing on the back end of the motor? Many thanks for your kind reply, Ralph Quote
woodbutcher74 Posted July 25, 2016 Report Posted July 25, 2016 I usually buy male tools, they are a lot less temperamental. Sorry just being a smartass. I would start with a volt meter and try and figure out where shes losing losing the voltage. Quote
Bonesandstones65 Posted July 25, 2016 Author Report Posted July 25, 2016 Ha! I agree, she's a female cause' she's being a pain in my ?! (That's a donkey!) Thanks, I'll give that a try! Ralph Quote
MisterDrow Posted July 25, 2016 Report Posted July 25, 2016 Your mention of blue light made me think of this... I fixed an old drill once with this fix (though I had to replace two of the brushes in the process). Don't know if you can get away with a fix like this but I share it anyways. Quote
knotscott Posted July 29, 2016 Report Posted July 29, 2016 Based on the existence of blue sparks, I'm assuming it's a universal motor, so I'd start with checking the condition of the brushes. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.