Nick2cd Posted January 20, 2011 Report Posted January 20, 2011 I have a ridgid 14" bandsaw. the small orange plastic insert that the blade goes through is not perfectly level with the cast iron table. it will sometimes cause a workpiece to get caught on the table during a cut. of course, there is often a ridge or divot in the cut that i accidentally make during the correction to free up the work-piece. is this normal? seems like a terribly obvious design flaw. im sure i can find a way to bring it up to be perfectly level with the table, but any suggestions would be appreciated. are there aftermarket inserts that work with the ridgid saw that would be a better fit? Quote
flairwoodworks Posted January 20, 2011 Report Posted January 20, 2011 Tape should work to shim it level. The throat plate on my General is fine. Most of the work I do on the bandsaw is large enough that I could work without the insert as well. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.