derekcohen Posted April 8, 2019 Report Share Posted April 8, 2019 This is what I did for my K3 sliding tablesaw: Melamine-covered chipboard ...This section connects to the outfeed table ...These bolts were used as supports on the chassis side ...This is the side with the table levelled, but not attached ...These are bolt holes for a rail (for the extension table) that will be used (later I attached the rails over the bolts to be added) ...I drilled a length of 3mm aluminium for a support ...Attached to the chassis ...The rail (for the extension table) is placed over it ...Screw the aluminium to the router table - this supports it on the far side (it is supported on the opposite side with bolts into the outfeed). And replace the extension table ...The router table from the top ....I have connected an Elu 177e with a Router Raiser and Muscle Chuck.I built the fence from aluminium square section and faced with adjustable Maple sections ...Dust is connected to the rear ...Hope this helps anyone kin the same position.Regards from PerthDerek 2 Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.