Recommended Posts

Posted

I picked up a delta 1440 type 2 lathe with a bad rear bearing in the headstock.  Trying to remove the spindle, I removed the hand wheel, and the back reeves pully.  The inner reeves pully looks like it is pressed into another bearing in the speed change yoke.  I have removed most of the snap rings, except the largest one facing the front of the spindle in the speed change yoke.  Has anyone removed the yoke?  do you have to remove the speed control lever to remove the yoke ?  can the reeves pulley in the yoke be removed without removing the yoke?

Any information on disassembling and removing the spindle will be appreciated.

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Who's Online   0 Members, 0 Anonymous, 26 Guests (See full list)

    • There are no registered users currently online
  • Forum Statistics

    32k
    Total Topics
    437.5k
    Total Posts
  • Member Statistics

    26,007
    Total Members
    3,644
    Most Online
    FurniCore
    Newest Member
    FurniCore
    Joined