Skip to content
View in the app

A better way to browse. Learn more.

Woodworking Forums & Project Advice | Wood Talk Online

A full-screen app on your home screen with push notifications, badges and more.

To install this app on iOS and iPadOS
  1. Tap the Share icon in Safari
  2. Scroll the menu and tap Add to Home Screen.
  3. Tap Add in the top-right corner.
To install this app on Android
  1. Tap the 3-dot menu (⋮) in the top-right corner of the browser.
  2. Tap Add to Home screen or Install app.
  3. Confirm by tapping Install.

Dealing with uneven shop floor

Featured Replies

I was wondering what everyones thoughts are in dealing with the uneven floors in the shop area when my workbench will be mos of the time. Should I leave the legs a bit long then trim to make the bench level and stable or keep the legs the same length and shim the bench to be level. If I shim the bench might that risk the bench moving or being less stable ?

Thanks

I was wondering what everyones thoughts are in dealing with the uneven floors in the shop area when my workbench will be mos of the time. Should I leave the legs a bit long then trim to make the bench level and stable or keep the legs the same length and shim the bench to be level. If I shim the bench might that risk the bench moving or being less stable ?

Thanks

I personally would shim the bench. Reason being if you build to fit the floor in a specific area and ever decide to move it, the bench will have the same problem you started with. I have a very uneven floor and will be building the base square, level and all equal dimensions. I will lighlty glue in some shims under the legs as needed. I don't foresee any issue with stability, being that the bench is going to weigh in at spproximately 350-400 lbs without tools on the shelf and etc. Another thing I am considering is build a wood floor around where I do all hand tooling. It is softer on the human legs and also on any tools that might fall onto it.

I've been struggling with this topic myself as the cement floor of my basement is rather thin, cracked and sloped near the walls. The place I have selected to put my bench slopes about 1-1/2 inches from left to right (I'm not yet sure about front to back, but it should be less). My thoughts were to create a foot from the leg material for the bottom of each leg that I would roughly scribe to the floor at each foot location. The thickness would vary from about 1" on the high side to about 2-1/2" on the low. To account for the added height I would lower the bench height from my calculated height of 34" to about 32-1/2" to blend out the difference from side to side. I thought to pin the feet to the bottom of the legs using dowels so that the legs will not slide off during aggressive planing or such. When (and if) I build a garage/shop with a smooth floor, I will remove the feet by cutting off the dowels and have a set of legs perfect for a flat surface (albeit slightly lower that I'd be used to).

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

Forum Statistics

  • Total Topics 32.1k
  • Total Posts 437.6k

Member Statistics

  • 26,011 Total Members
  • 3,644 Most Online
  • bobtjanitor Newest Member ·

Account

Navigation

Search

Search

Configure browser push notifications

Chrome (Android)
  1. Tap the lock icon next to the address bar.
  2. Tap Permissions → Notifications.
  3. Adjust your preference.
Chrome (Desktop)
  1. Click the padlock icon in the address bar.
  2. Select Site settings.
  3. Find Notifications and adjust your preference.