Recommended Posts

Posted

I was looking for opinions on honing a secondary bevel on the blade of a LN low angle rabet block plane. The blade is bedded at 12 degrees and factory sharpened at 25 degrees for an overall angle of 37 degrees. If I were to put a secondary bevel on this blade the effective angle would be closer to 40 degrees. Will that negate any benifits of a "low angle" plane?

Posted

The benefit of a low-anlge, or bevel-up, plane is that you can create almost any cutting angle that you want. I would try putting the secondary bevel on and see if it cuts well for you. If it doesn't, regrind the primary bevel to something steeper/shallower and try again.

Jonathan

======================================

Posted

The choice to use or not use a secondary bevel is, to me, more about preferences in sharpening techniques. I wouldn't worry about a couple of extra degrees. I don't think you'll notice any difference between 40 and 37. Plus the slightly steeper angle on the blade will improve the strength of your cutting edge. 40 is still a pretty low angle, and even higher angles will cut end grain just fine if you keep your blades sharp.

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.