JusticeBeaver Posted June 10, 2012 Report Posted June 10, 2012 My poor old Delta CMS gave up the ghost this weekend. Motor kept running for a few seconds after I released the trigger, strange noises like it was crying and even a little burning smell. I'm looking at the Jet 10 inch SCMS but I can't find many reviews. Anyone have an opinion on a 10 inch SCMS? Also looking at the Bosch 4310. Sorry if this has been discussed, I couldn't find a reference to the Jet. Thanks! Quote
woodwhisperer Posted June 11, 2012 Report Posted June 11, 2012 I used the Jet for a couple of years after my Makita was stolen from my shop. In many ways, it reminded me of the Makita (a good thing). My ONLY issue I had with it was that the sliding mechanism would repeatedly have a hiccup. Basically, debris/dust was getting into the bearings and causing a small sticking point as the head was pushe in and out. Just enough to make you nervous and possible affect the quality of cut. I would use compressed air and a vac to clean everything up, then I'd lubricate the rail and that would usually take care of it. But within a few weeks of use, the problem would be back again. Could just be the unit I had but it was quite annoying. Other than that one thing, it was a great saw. Quote
JusticeBeaver Posted June 11, 2012 Author Report Posted June 11, 2012 Appreciate the feedback! Now I just need to figure out where to put it... Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.