snider.mark@gmail.co Posted June 15, 2012 Report Posted June 15, 2012 I bought an Incra router table and the Master Lift II. I can't for the life of me get all sides of it level at one time. I have been working on it for two days for a total of about 7 hours and am now beyond frustrated. I have gotten close several times but there is always one edge or corner that screws it all up. Does anyone know a secret to the 10 screw adjustment nightmare so I can move on to the woodworking phase of my life? Totally Frustrated! Quote
pagel Posted June 16, 2012 Report Posted June 16, 2012 I have Jessem's Mast-R-Lift II system and believe they're pretty much the same because Jessem manufactures Incra's Mast-R-Lift II model for them. Mine came with four flathead cap screws that secure the lift to each corner of the table. Did yours come with these cap screws? I was having similar problems and was only able to get everything reasonably level by screwing in the four cap screws first but without snugging them in all the way. I then began adjusting the leveling screws, then snugging the cap screws a little more, back again to readjusting the leveling screws (very touchy) and so on until the four cap screws were snug and tight. It took me quite awhile before I was finally satisfied with the results. Yeah, it wasn't a pleasurable experience... Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.