Keith Gallagher Posted January 10, 2013 Report Posted January 10, 2013 I got the above bandsaw a while back and have only been using it for cutting blanks for woodturning. I have spent a while today fine tuning it for other work such as cutting tenons but found there is no obvious means of squaring the fence to the table. Does anybody know how to do this? The bandsaw is similar to the Jet 18Q and 20Q model. Another thing I wanted to find out is, is it possible to build a Biesemyer style rail for a Jet tablesaw? I was looking at them online but the shipping to Ireland kinda puts it out of my reach at the moment. I tried to find a photo from the manual online to show the profile of the current rail but couldn't find one. Quote
dwacker Posted January 10, 2013 Report Posted January 10, 2013 If its just a jet aluminum fence the bolts that hold the fence to the handle are the drift adjustment. The rail is bolted to the table with oversized holes for small adjustments. Don Quote
Keith Gallagher Posted January 10, 2013 Author Report Posted January 10, 2013 Hi Don. I have it set for drift. It's the face of the fence that is not square to the table. I may have to shim underneath the fence to tilt it over. Looking through the manual it doesn't show how to square it. Quote
dwacker Posted January 10, 2013 Report Posted January 10, 2013 Square your table to the blade. Don Quote
Keith Gallagher Posted January 10, 2013 Author Report Posted January 10, 2013 Done that too but it doesn't help square the fence. I thought where the bolts are for adjusting the drift would also square it up but it doesn't. Quote
dwacker Posted January 10, 2013 Report Posted January 10, 2013 To adjust the fence square to the table would mean moving the rail up or down on one end or another. Don Quote
Keith Gallagher Posted January 10, 2013 Author Report Posted January 10, 2013 Sorry about the dark photos. The second photo shows the nylon blocks that slide along the rail. I watched Marc's video a while back on setting up a tablesaw where something similar to these were underneath the fence. On his though there were nylon screws to adjust the fence square to the table. Quote
Keith Gallagher Posted January 10, 2013 Author Report Posted January 10, 2013 To adjust the fence square to the table would mean moving the rail up or down on one end or another. Don I done that with the front rail but not the back one. It improved it a little but it's still not fully square. I'll go at it again tomorrow and see if I can get it right. Thanks Don. Quote
Byrdie Posted January 12, 2013 Report Posted January 12, 2013 Don's right. One end of the guide rail needs to be raised/lowered to align. If you have rails on both ends of the fence (sounds like you do) both need to be moved equally to remain parallel to one another or you create twist in your fence. Quote
Keith Gallagher Posted January 12, 2013 Author Report Posted January 12, 2013 Thanks guys. Got it sorted and got everything else tuned up. Happy out. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.