tdh36185 Posted April 29, 2013 Report Posted April 29, 2013 I have a rather old bandsaw (General, from what I can tell, there is no plate on it anymore), and every time I turn around to do something it seems that I have to "fix" it. The bearing guides on the bottom like to fall off and regardless of how much time I spend adjusting them the blade always makes contact with one of the guides yielding more noise than is necessary. I recently was working with the bandsaw, everything going great, and then out of nowhere the tire decides that it has lost all desire to stay in contact with the wheel. I replaced the tires with the orange polyurethane tires and though all was well. For some reason the upper tire does not stay on, even with using contact adhesive. The tension coil is definately due to be changed. The motor runs fine, but the keyed drive shaft allows the pulley to slip, so i routinely bust out the mallet and hammer it back into "parallel" with the motor, and of course try to tighten the pulley. So is it worth while to scrap the recent tire purchase, replace the guides with carter guides, obtain new tires (again), replace the tension coil and replace the keyed drive shaft and pulley or just buy a new bandsaw? Quote
TRBaker Posted April 29, 2013 Report Posted April 29, 2013 We use bandsaws like that in Mobile Bay, for artificial reefs. Quote
Levi Rathje Posted April 30, 2013 Report Posted April 30, 2013 Unless it is a big saw 16" or bigger replace it. You will likely have half the price of a new one or more in it. The newer saws have better fences dust collection and are usually safer to use. I think a 14" Grizzly is just over$500. Quote
ChetlovesMer Posted April 30, 2013 Report Posted April 30, 2013 I have to say, it seems like Grizzly bandsaws are as good a value as there is out there. For the money, size, features, etc... they seem really hard to beat. I hope to replace my bandsaw by the end of the year, so I've begun researching them. There's a lot to like with the Griz bandsaw. Quote
tim0625 Posted May 1, 2013 Report Posted May 1, 2013 I bought an 18" Jet, one year old, off of Craig's list for $800. If you like working on things....tools, cars, etc keep tinkering; but if you're like me, I can work on things but I try not to....and I don't have an abundance of time so when I get to the shop and hit the switch, I want to work wood, not tools. My OLD craftsman table saw was like that....it seemed that there was always some little issue that kept me working on the saw and not the wood. When I bought my new TS, I've never regretted spending the money. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.